SM2 - MAGNETIC MOUNTING SYSTEM
Experience the Future of Mounting Systems
Now Stronger, Smarter, more Reliable and compatible with more footprints.
Engineered for speed, reliability, and unparalleled ease, our system is a game-changer for enthusiasts and professionals alike.
Experience the next level of mounting systems with innovative magnetic mechanism
With the gun unloaded, remove the original rear sight. If in doubt, please contact a gunsmith.
EASY TO ASSEMBLE
Loosen the screws without separating the parts and slide the rear sight assembly into the dovetail as indicated in the diagram.
Center the rear sight assembly and progressively hand tighten the screws with the supplied Allen key.
Do not over tighten. It is advisable to fix the screws with an adhesive intended for this purpose.
The recommended tightening order is the side screws first and the center screw last.
Position the device by supporting the rear of the sight and rotate down wards to insert the rear sight into the device mount housing until the magnet contacts the top of the pistol slide.
To check its correct placement, look at the back of the weapon and verify that, once the device is installed, the rear sight is not visible and is completely hidden.
Optionally and for your convenience, you can place the Allen key for adjustment of windage and elevation in the housing located for this purpose on the side of the device, from left to right, which also provides extra fixation.
In case you want to remove the device from the gun, you must remove the safety Allen key and rotate it in the direction of the red arrow in point 4.
1. Install the new rear sights.
This will serve as the mounting base for the magnetic mounting system
2. Mount your sight in the magnetic mount
No modifications to your pistol or your dot sights required.
3. Just calibrate the first time and done!
Calibrate your new rear sights and you are good to go!
4. You are ready to go!
Setup is done!
More versatile than ever
Compatible with RMR, RMS and DDP footprints
(-) Button decreases intensity
Elevation Adjustment
(+) Button increases intensity
CR 2032 Battery
Windage adjustment
LED
Frenzy-S 1x17x24 MIC Pistol Red Dot Sight
- 3 MOA Dot Size, Standard Window Size Design for Accurate Aiming over 50yds
- Motion Sensor Feature No Worry to Forget to Switch Off the Sight, Extend the Use
- Super Low Profile, Only 7mm / 0.3inch Height That Won't Block Your Pistol Sights
- IPX6 Waterproof Ensures Reliable Performance in Heavy Rain, Ideal for Outdoor Use
3 MOA Dot Size
Popular Size to Balance Precision and Speed
NV-Compatible Illumination
NV Illumination for Taking Shot at Night
Parallax Free
Point of Aim Aligns with Point of Impact
Motion Sensor
Effortless Activation and Battery Savings
IPX6
Durable Against Heavy Rain
Lightweight Design
Lighten Your Load, Aim with Ease
Plinking
Design for Plinking
It is one of the strongest footprints and is widely used on duty pistols and tactical platforms.
Characteristics
- Two mounting screws (front-to-back)
- Two recoil lugs/pins in front
- Very strong design (metal-to-metal contact)
It is very common on slim/compact pistols (Glock 43/48 MOS, Hellcat, etc.).
Characteristics
- Two mounting screws (top-down)
- No front recoil lugs – uses shallow alignment posts
- Smaller and narrower than RMR
- Designed for micro/compact opticsrate.
Characteristics
- Larger footprint compared to RMR/RMS
- Two mounting screws
- Two rear recoil lugs
- Used mostly on full-size pistol slides and carbines
